CD4060 Timer Circuit 1 minute to 2 hours

 

CD4060 Timer Circuit 1 minute to 2 hours

This is a 1 minute to two-hour timer switch. The 14-stage binary ripple counter Type 4060, IC1, has an on-chip oscillator capable of stable operation over a relatively wide frequency range. In the present circuit, the oscillator frequency is determined by an external RC network connected to pins 9, 10 and 11.

PARTS LIST
R1	2.2MΩ
R2	18KΩ
R3	1KΩ
R4	1KΩ
R5	1KΩ
R6	1MΩ
VR1	500KΩ (504)
C1	220nF (224)
C2	10nF (103)
D1	LED
D2	LED
D3	1N4001
Q1	BC547
IC1	CD4060
RL1	Relay

When the power is on, the pulse at junction R6-C2 resets the counter and counting starts. When the counter reaches bit 14 (Q13), pin 3 goes high so that the relay, a 9V type, is turned on via driver Q1.

CD4060 IC PINOUT

The time delay is set with the aid of VR1. Time delays of between one minute and two hours are possible by appropriate dimensioning of the timing components:

1-30 minutes: C1 = 220nF ; VR1 = 500KΩ.
1-60 minutes: C1 = 470nF ; VR1 = 500KΩ.
1-120 minutes: C1 = 470nF ; VR1 = 1MΩ.

The timer is powered by a 9V PP3 battery. Light-emitting diode D1 does not affect the operation of the circuit and is included merely to show that the timer works. Diode D1 and resistor R4 are , therefore, optional components.